Sidewall conveyor belts (corrugated sidewalls, cleats)

Advantages

• operation at steep inclines, up to vertical conveying

• higher capacity for the same belt width

• less space and fewer conveyors

• less material spillage

• the belt can run from a horizontal into an inclined or vertical section

Applications

• quarries, concrete plants and cement plants

• thermal power plants and power generation

• foundries and steel mills

• mines

• recycling and waste treatment

• wood industry – chips

• ports – ship loading and unloading

• silos and bulk storage

Belt components

• Base belt – a special cross-rigid belt that does not sag between the sidewalls; for light and heavy-duty operating conditions

• Sidewalls (corrugated) – corrugated rubber edges, approximately 40 to 400 mm high; higher sidewalls have fabric reinforcement

• Cleats – transverse cleats that carry the material; straight for moderate inclines, inclined for steep and vertical conveyors

• Side baffles for fine and dusty material, if required

Rubber versions

• abrasion-resistant (standard)

• moderately oil-resistant

• heat-resistant

Self-extinguishing and antistatic versions for use in ATEX zones (explosion-hazard areas) are available on request.

How we select the belt

We determine the sidewall height and the type and pitch of the cleats based on the material, lump size, capacity and conveyor incline. The cleat must be lower than the sidewall, and the cleat pitch and width depend on the largest lump of material. For the right choice, send us details of the conveyor and the material.

Installation, splicing and repair

• We deliver and install the belt on site.

• We join the sidewalls and cleats by cold vulcanising.

• We repair and replace damaged sidewalls and cleats on the existing belt – without replacing the whole belt.

Conveyor belt vulcanising and splicing →

How to request a quote

Send us:

• a sketch or photo of the conveyor (horizontal, inclined and vertical sections, incline)

• belt width and length

• type of material, largest lump size and approximate temperature

• required capacity

• designation of the existing belt, if any

Enquiry form →

FAQ

Up to what incline does a sidewall belt work?

Up to vertical conveying (90°), depending on the cleat design.

Can a damaged sidewall be repaired?

Yes – we repair or replace damaged sidewalls and cleats on the existing belt.

Is it the same as a chevron belt?

No. A chevron belt has low cleats and works up to about 40°; a sidewall belt has sidewalls and cleats and also works at much steeper inclines. Chevron belts →