Heat-resistant conveyor belts

Applications

• cement plants – clinker, cement, hot material from mills

• asphalt plants – hot aggregate and asphalt

• heating plants and power generation – ash and slag

• foundries and steel mills

• chemical and metallurgical industry

• mineral wool and glass industry

Resistance grades

The belts are available in four heat-resistance grades – from versions for material at about +120 °C to versions that withstand short peaks of up to +400 °C. The actual permissible temperature depends on ambient temperature, grain size of the material and contact time with the belt – so we advise on the right grade for each case.

Versions that are both heat and oil resistant are also available on request.

Antistatic and self-extinguishing versions for use in ATEX zones (explosion-hazard areas) are available on request.

Sizes and availability

• We supply heat-resistant belts to order, at short notice – according to the resistance grade, width and construction you need.

• Various widths and constructions on request.

Splicing heat-resistant belts

For these belts we recommend hot vulcanising with material matched to the belt's resistance grade – a cold splice is not suitable for continuous operation at high temperature. Conveyor belt vulcanising and splicing →

How to request a quote

Send the belt designation, width and length, type of material and its maximum temperature on the belt. Enquiry form →

FAQ

How do I know which grade I need?

By the material temperature at the loading point; we also consider grain size and how long the material stays on the belt.

Why is my belt cracking and hardening?

Usually the cover's heat resistance is too low for the material temperature.

Can a heat-resistant belt be cold spliced?

For continuous operation at high temperature we recommend hot vulcanising.